Facade glazing
Transparency, translucency, and opaque screen printing
Linear glass façade
The linear glass façade is the high-quality alternative to plaster or various types of paneling in the course of energy-efficient thermal insulation. The glass panels are finished with opaque screen printing and the profiles are attached to a substructure or fixed tightly to the wall. The print faces the wall so that the glass surface has an unrestricted shine and is protected from the weather. Windows and doors can be seamlessly integrated into the rear-ventilated cold façade. Rain gutter or blind connections and corner solutions are also possible.
The profiles are mounted horizontally; the glass pane is supported from above and below and fixed in place with a rubber profile. The milky-transparent seals at the front are discreet and barely noticeable. The profiles are 37 mm high and available in matt chrome or white. Other coatings are available on request. The glass elements made of ESG-H safety glass are 6 mm thick up to a height of 1300 mm and 8 mm thick up to a height of 1700 mm. The formats are adapted to the safety regulations for wind loads. The glass panels are waterproof and easy to clean.
Advantages at a glance
- Modern, unusual design
- Individual design freedom in almost all colors according to customer requirements
- Easy to clean
- Quick and easy installation
- Excellent price/performance ratio
- Quality "Made in Germany"
Technical details
- Glass panels are finished with opaque, ceramic screen printing
- Windows and entrances can be seamlessly integrated
- Corner solutions are just as possible as rain gutter or blind connections
- Profiles are mounted horizontally
- Profile height is 37 mm
- Available in matt chrome or white, other coatings available on request
- Glass pane is supported at the top and bottom and fixed in place with a milky transparent silicone profile
- Branded silicone profile with excellent weather and UV resistance
- Glass elements made of ESG-H are made of 6 mm ESG for heights up to 1300 mm and 8 mm ESG for heights up to 1700 mm
- Formats depend on the respective wind zone
- Heat-soak test included in the price
- Easy installation of the one-piece profile system without additional cover profile
- Rear-ventilated cold facade
- Cover plates also available
- Aluminum profile with screw channel for side closures
- Glass processing (drill holes, sections, bevel cuts, etc.) easily possible on request
Point-fixed glass façade
A special holder holds the glass façade panels discreetly and at the same time prevents overloading at the holding points thanks to its own flexibility. The exact selection of the statically required glass thicknesses and the number of point fixings required is determined by calculation programs. For even more protection, the stability is verified by accompanying test trials depending on the application.
For façade glazing, glass in the ESG-H category (heat-soak tested material) must be used in accordance with DIN 18008. We therefore recommend using products made of Spridur ESG-H or VSG made of ESG or VSG made of TVG.
Our SpriPoint holders are supplied as point holders or glass clamp holders for different thicknesses of glass. We therefore offer you complete solutions consisting of glass elements and holders for façades, all-glass systems, elevator shaft glazing, balustrades, overhead glazing, stairs and walk-on glass floors.
